Centrifuge for Conical Tubes
       Installation date: January 2007

  •   Compatible with 50ml/15ml conical tubes as well as 2.0ml/1.5ml tubes.
  •   Maximum RPM: 10,500rpm (gmax: 13,200ⅹg)
  •     NOTE: The maximum RPMs differ depending on the tube materials. Please refer to the catalogues.
  •     Temperature range: 5~30℃

  •   You must receive a training session.
  •   There are restrictions on time of use: weekdays from 9:00AM to 5:00PM
  •   Be sure to balance the samples before use and confirm that the rotor's.
  •   After use, be sure to check inside of the rotor and clean it if there are any spills.
  •   Leave the door half-open to evaporate any water after refrigerated runs (a staff member will close it later).

  About training session
  •   We conduct training sessions as needed. Please contact us in advance to adjust the schedule.
  •   The training session takes approximately 20 minutes.
  •     Please bring your samples.


Copyright(C)The Research Support Center, Research Center for Human Disease Modeling,
Kyushu University Graduate School of Medical Sciences. All Rights Reserved.