High-speed centrifuge
       Installation date: January 2009

  •   Enables high-speed and large-capacity centrifuging.

  •   You must receive a training session.
  •   Samples contaminated with viruses or pathogens are not allowed to be used.
  •   Bring your own consumables.
  •     NOTE: The maximum RPMs differ depending on the tube materials. Please check this before purchasing.
  •   Be sure to balance the samples before use and confirm that the rotor's O-rings are correctly placed.
  •   After use, be sure to check inside of the rotor and clean it if there are any spills.
  •   Leave the door half-open to evaporate any water after refrigerated runs (a staff member will close it later).

  About training session
  •   We conduct training sessions as needed. Please contact us in advance to adjust the schedule.
  •   The training session takes approximately 40 minutes including safety training.


Copyright(C)The Research Support Center, Research Center for Human Disease Modeling,
Kyushu University Graduate School of Medical Sciences. All Rights Reserved.