The following five can be detected with a monochrometer.
Fluorescence
Luminescence (Also capable of BRET detection)
Absorbance
Time Resolved Fluorescence
Fluorescence Polarization
The following five measurements are available.
Endpoint : 1-time measurement
Kinetic : repeated measurement at set time intervals
Spectrum : measurement across the spectrum of given range of wavelengths
Well Scan : measurement of more than 3 locations within a well (only for non-uniform adherent cells)
Flex : real-time cell-based kinetic assay
Temperature control is available
Room temperature +1℃ to 45℃
Rules
You must receive a training session.
There are restrictions on time of use: 2hours (Please consult with us if you want to use it longer.)
96 well plates are most commonly used but 6, 12, 24, 48, and 384 well plates are also available depending on the measurements.
The recommended total volume loaded per well for 96 well plate: 200μl (minimum 150μl)
Bottom read and absorbance are also possible with 100μl if the liquid surface is flat and horizontal.
About training session
We conduct training sessions as needed. Please contact us in advance to adjust the schedule.
Please contact us after you have determined when you will start using.
The training session takes approximately 1 hour.
There is no need to bring a sample, but if you wish to bring one please let us know.
Settings
Copyright(C)The Research Support Center, Research Center for Human Disease Modeling, Kyushu University Graduate School of Medical Sciences. All Rights Reserved.